This specification covers austenitic stainless steels in the annealed and normally required cold-worked conditions. Only annealed conditions of grades speci? Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. C Annealed material that naturally meets mechanical properties may be applied. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters. B Maximum unless otherwise indicated.
|Date Added:||26 July 2017|
|File Size:||40.55 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Last previous edition approved in as A — Mechanical properties such as yield strength, tensile strength, elongation, hardness, and bending shall be determined. B Type is generally a666 with a chemical composition balanced for rich side Type astm a666 lean side Type austenite stability depending on the properties required for speci?
The values given in ashm are for information only. They shall be formed in astm a666 shapes such as sheets, strips, plates and flat bars. Rockwell B 95 95 Number of Tests 8. B Maximum unless astm a666 indicated. This standard has been approved for use by agencies of the Department of Defense.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. HardC Elongation in 2 in. This revision of Speci? The values obtained in this manner should not, however, be taken as the actual yield strength for 0.
ASTM A666 for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar
Hard Elongation in 2 in. Depending on the work hardening characteristics of the particular grade, either the yield or astm a666 tensile strength can be the controlling factor in ashm the properties. One bend test shall be made from one end of each coil. The specimens shall be subjected to tension test, free-bend test, and controlled-bend or V-block test.
It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its astm a666 and application. ICS Number Code Historical Version s – view previous versions of standard.
A superscript epsilon e indicates an editorial change since the last revision or reapproval. Only annealed conditions of grades specifically approved by the ASME code are permitted for pressure vessel use. C Annealed material that naturally meets astm a666 properties may be applied.
D PSS means plate, strip, sheet.
ASTM-A Alloys | E. Jordan Brookes Company
Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters. A number in parentheses indicates the year of last reapproval. In case of dispute, the offset method of determining yield strength shall be used.
If you feel that your comments astm a666 not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address shown below.
Specimens shall be bent around a diameter equal to the product of the bend factor times the speci? This specification covers austenitic stainless steels in the annealed and normally required cold-worked conditions.
The noncontrolling factor normally will exceed considerably the speci? Users of this standard are expressly advised that determination of the validity of any astm a666 patent rights, and the risk of infringement of such rights, are entirely their own responsibility. Link to Active This link will always route to the current Active version of the standard. Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or at phonefaxor service astm.
ASTM does not give any warranty express or implied or make any q666 that the contents of this abstract are accurate, complete or up to date. An alternative method of determining?